Laurel-electronics LTA DPM SERIES ANALOG INPUT Instrukcja Użytkownika Pobierz pdf (Strona 22)

- 22 -

14. MAIN BOARD JUMPER SETTINGS

c ab

Serial Signal Duplex Jumpers Termination Resistor*

Full None

E6 a = Transmit

E6 c = Receive

RS485

Half E6 b + d** E6 c

RS232 Full None None

* The termination resistor jumper settings should only be selected if the transmitter is the last

device on an RS485 line longer than 200 feet (60 m).

** Or jumper external BTX to BRX and ATX to ARX (same effect as internal jumpers).

To reset communications to 9600 baud, command mode, Custom ASCII protocol, and Address 1,

place a jumper at E1 and power up the transmitter.

Analog Output Jumpers

Current E2 a + d

Voltage E2 b + c

Excitation Output* Jumpers

5V, 100 mA E3 a + c; E4 a

10V, 120 mA E3 a + c; E4 b

24V, 50 mA E3 b, E4 none

* Attempting to draw more than the rated current will shut down the output.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Brak uwag

Laurel-electronics LTA DPM SERIES ANALOG INPUT Instrukcja Użytkownika Strona 22